Your Bitmain Antminer L7 needs to be cleaned once a month in order to prolong its lifespan. You can dust and clean the Bitmain Antminer L7 by following the instructions in this manual.
When Should I Clean and Dust the Bitmain Antminer L7?
1. When you discover the dust-covered Bitmain Antminer L7 miners‘ casing.
2. When it is discovered that the Bitmain Antminer L7 miners are not functioning correctly because of dust buildup or other debris attach on the hash board which affect the heat dissipation.
Read more: Bitmain Antminer L7 Normal Operating Temperature Range
3. When you examine the Bitmain Antminer L7. Clean the dust regularly, we recommend doing it once a month
*IMPORTANT: It’s important to stop the miners.
How to Clean and Dust the Bitmain Antminer L7?
Equipment: Air Compressor + Air Gun
Air Pressure range: 0.7 +/- 0.05 MPa
1. Use the air gun to gently blow the front and rear fans twice
2. Put the air gun close to the fan, taking care not to touch the grille or the fan blades to avoid damaging them. Blow each gap for two to three seconds, then repeat the process two or three times.
You must take out the fan and brush out any stubborn dust if the air gun cannot remove it due to the high humidity (which makes the dust stuck).
Please don’t hesitate to get in touch with us if you have any questions.
